Fitting Carpet Runner On Stairs

Use carpet tool and rubber mallet to pack runner tightly between the tackless strip and the riser.

Fitting carpet runner on stairs.

If you have pie shaped or curved stairs install the carpet on the riser in the same way as mentioned above. 90 degree turns these are easy. Fit the carpet runner first. Ease each bracket apart by taking out the dome headed screw and sliding apart using your fingers.

Click show more for links and resources stonegate carpets http bit ly 2drtd4w contact us resto. If you want to know how to remove carpet easily from stairs check this out as companies charge uptown a few hundr. Staple each edge of the runner 2 inches above bottom of riser. Apply firm pressure evenly across the width of the runner with the bolster.

The very last piece of the stair renovation jigsaw. If the step has a nose you can fix the landing carpet to the underside of it. When you find a remnant or a piece of carpet it will essentially be cut into sections that will be installed end to end giving the appearance of a seamless runner on the stairs. The only main difference is that there will be a lot more excess to trim.

Near both ends of the tackless strip staple the runner into the crease where riser meets tread. Start at the bottom of your staircase. Even pre made runners are cut into pieces to allow proper fitting to the stairs. Place the bottom part of each pair of brackets either side of the runner adjacent to the carpet edge and in the angle where the tread joins the riser.

Runners are not installed on the stairs in one piece. Take the stair carpet up to the top of the final riser tack it into place and trim it off in a neat line. Measure so that the carpet will be flush to the wall and curve completely over the tread. Secure the runner using the bolster and mallet secure the runner into the groove of the stair.

Tap along the runner to secure it into place by doing so you will ensure a firm hold from the carpet gripper which sits underneath the runner. Beginning at the top of the stairs measure a stair tread or landing and transfer the measurement to the back of a piece of carpet with marker or chalk. For the tread start as mentioned above by fastening the carpet to the floor under the nosing and bring the carpet straight over the lip and across the tread. Gripper and underlay should be used under stair runner carpets in the same way as they are used for any other carpet.

Pull the landing carpet down over the edge of the top step.