Fix Pull Chain On Ceiling Fan

Next remove the cover on the fan housing or the globe light so you can access the switch and unscrew the nut on the outside of the switch that holds it on.

Fix pull chain on ceiling fan.

This video is for en. To fix and replace a bad on off light switch inside the ceiling fan. Disconnect these wires and pull out the switch. Removing the fixture housing.

If your ceiling fan or the light on the fan doesn t work when the chain is pulled then the problem is most likely a broken fan pull chain switch. Remove the light fixture housing from the fan. How to replace a ceiling fan pull chain switch method 1 of 4. Examine the switch to see if the chain can be reattached.

Cut the wires to the ceiling fan pull chain switch with the wire stripper use the cutting section to snip off the two wires that attach the pull chain switch to the ceiling fan base. If needed take it. Leave at least two inches of wire attached to the ceiling fan base to make it easier to reattach the new pull chain switch. Locate the wire connections from the pull chain switch to the unit.

Pull chain switches for light fixtures and ceiling fans can become a problem over time due to internal worn out parts a broken pull chain and in some cases the pull chain switch contacts may just wear out and stop working. The plate is typically held on to the rest of the housing with three screws on the. Replacing a broken pull chain switch on a ceiling fan. Today we fix a pull chain for the fan control of a ceiling fan for free.

This is an easy fix that takes little time. Pop open the switch using a small screwdriver. Pull the switch out of the housing from the inside leaving the wires attached. An easy repair you.

If the chain on your ceiling fan has ever pulled out then this is how to repair it. Leverage open the tabs along the. Climb a ladder to access the fan and open the cover plate at the bottom of the fan where the pull chain enters. The first thing i would do in a situation like this is to consider replacing the pull chain light switch.

Next remove the end cap by turning it counterclockwise and pulling it over the chain to remove it from the fixture. The switch will also need to be replaced if the chain will not pull down or if it broke off inside the fan housing. Replace the old switch with a new pull chain switch then place the end cap back onto the light fixture. Turn the power off at the circuit breaker for safety.

Replacing the pull chain. Start by turning off the circuit breaker to the fan.