Fan Light Remote Control Not Working

So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan.

Fan light remote control not working.

Yes the ceiling fan remote control module may be faulty. If the ceiling fan and light works normally then the remote control module will need to be replaced. If fresh batteries and altering the settings on your fan receiver and remote did not work you may have a damaged remote control. Confirm the reverse switch is not in a neutral position.

Replace the batteries in the remote control and turn the power back on. Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. Replace it with a universal model or get a replacement recommended by the fan s manufacturer. Ensure that the fan s receiver and dip switches behind the remote are on the same frequency.

Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds. Now we know the buttons don t work did you try to change the battery. The fan will turn on and light if applicable will blink three times signaling a successful synchronization replacement remoteif the fan works without the remote via a pull chain or switch but not with the remote even though they have the same settings the remote has probably gone bad and you will just have to get a replacement remote. Test to determine whether the batteries are dead.

Turn the ceiling fan off. If you are using a remote or. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. Follow the steps below to determine the cause.

Remove the batteries from the remote control and wait for about 10 seconds. Flip the switch several times to make sure it is the right. Remove the back of the batteries to check if you have inserted them correctly. Similarly try to turn on the light by using the remote.

If you have an older ceiling fan the switch may be worn out. When to buy a new ceiling fan. If no luck turn on the light by pulling the light pull chain. If it will turn on the fan but not the ceiling fan lights try resetting the remote control.

The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. If the remote control of your fan is not working here is what you can do to try and fix the problem. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. In this case replace the reverse switch.